Silenced Pneumatic hammer with Retainer Ring:

Connection: 12,5 mm

Weight: 1650 gr

Working pressure: 5 bar

Air Consumption 200 l/min

Beats per minute: 5000

The mean frequency weighted acceleration value of this hammer, measured over the handle during chiselling operations on stone is 16,4 m/s2.

TRANSPORT:

The hammer is sent packed. Do not wet the machine with water or use solvents, particularly on the exgernal rubber covering so as to avoid damages.

INSTALLATION AND STARTING UP:

Connect the machine up to the compressed air circuit with a G1/4  connector. Never remove the connectors already installed on the machine.

The working pressure of the hammer is 5 bars. The working pressure must never be raised above 6 bars. The hammer can still be used at lower pressures (not less than 2 bars), depending on the results required. It is advisable to insert a pressure regulator into the system before the machine so as to ensure a constant flow of air.

Only compressed air which is purified and desiccated must be used. Do not lubricate the machine.

MAINTENANCE AND CLEANING:

iT IS RECOMMENDED THAT THE MAITENANCE AND THE CLEANING SHOULD BE CARRIED OUT WITH THE EQUIPMENT DETACHED FROM THE COMPRESSED AIR SUPPLY.

SPARE PARTS:

Original spares should be used at all times to ensure the reliability and safety of the machine.